Nozzle Cleaner SMT Cleaning Equipment Energy Efficient Cleaning Low Noise Automatic

Nozzle Cleaner SMT Cleaning Equipment Energy Efficient Cleaning Low Noise Automatic Advantages:
 
1. No cleaning solution is required
2. low noise
3. Energy efficient
4. Wash 36 nozzles one time
 
Machine Description:
 
The latest intelligent nozzle cleaning machine CW-36 with a moving fixture, dry at the same time while cleaning. Clean 36 nozzle per time, breaking the traditional cleaning machine cleaning methods and the number of restrictions. It uses pure water or DI water to clean, cleaning effect is good, cleaning rate of 99% or more, after this upgrade to join the intelligent detection of water storage device, whether the lack of water or too much water affect the cleaning effect function, no need to worry about water lacking or more water, so cleaning more peace of mind, more intelligent. Standard equipped with a special nozzle detection device for the nozzle after cleaning detection.
 
Machine Feature:

1. Clean 36 nozzles per time, quicker and more efficient
2. Automatic cleaning, avoid troubles caused by ultrasonic cleaner, reduce rejection rate.
3. To clean the dirt completely which ultrasonic cleaner can not deal with
4. Cleaning result will not affect by the smaller and smaller nozzle
5. Thoroughly clean 99% dirty nozzle, extend the lifespan of nozzle
6. Protect the coating surface of nozzle and its reflection panel.
7. Never use solvent, only environmentally friendly DI water is enough
8. Easy operation
9. Applicable to all kinds of mouter nozzles, especially on corss, I-shape, odd shape nozzles

Machine Specification:
 

Contrast with traditional cleaning:

1, Artificial wind guns

① Manual cleaning efficiency is low, the nozzle surface and the lumen can not be cleaned, the hole with a steel wire stabbed easily damaged;

② Cleaning effect difference;

③ The use of cleaning fluid and alcohol may penetrate to cause the reflective layer to fall off.

2, Ultrasonic cleaning

① Low cost and high efficiency;

② Cleaning process can easily lead to collision

between the nozzle, resulting in damage to the surface

of the black coating or fall off;

③ Cleaning fluid on the nozzle surface coating damage, greatly reducing the use of nozzle life;

④ Can not completely clean the nozzle surface and lumen;

⑤ For the latest 01005 and 0201 nozzle can not be a

good cleaning, mainly due to the nozzle hole is too small, ultrasonic cleaning can cause vacuum bubbles can not be discharged and cleaning is not clean. 

Contrast with ultrasonic cleaning: